| *** tpb has joined #tomu | 00:00 | |
| *** deltab has quit IRC | 01:42 | |
| *** deltab has joined #tomu | 01:49 | |
| *** andi- has quit IRC | 03:42 | |
| *** andi- has joined #tomu | 03:46 | |
| *** Rondom has quit IRC | 08:54 | |
| *** Rondom has joined #tomu | 08:54 | |
| *** im-tomu has left #tomu | 09:56 | |
| *** im-tomu has joined #tomu | 09:56 | |
| tnt | Can foboot write at a specific place in flash ? I have a design that has both a bitstream and a riscv fw that it will load from a specific flash address so I need to write it there beforehand (obviously). | 12:14 |
|---|---|---|
| xobs | It currently cannot. It will always write to `0x20040000`. | 12:15 |
| tnt | ack, thanks for confirming I didn't miss anything. | 12:19 |
| *** earthnative has quit IRC | 14:12 | |
| *** earthnative has joined #tomu | 15:53 | |
| *** Vercas has quit IRC | 16:00 | |
| *** Vercas has joined #tomu | 16:01 | |
| *** im-tomu has left #tomu | 16:12 | |
| *** im-tomu has joined #tomu | 16:13 | |
| *** f0x has joined #tomu | 19:50 | |
| f0x | hey all! As a small project I wanted to make some adaptations to the Tomu, with at least an rgb led (but no fpga) | 19:52 |
| f0x | using JLCPCB's SMT service was appealing to me, but they only do >1.0mm boards, will that be too thick? | 19:53 |
| f0x | looking at the sizes, 1 (pcb) + 0.9 (efm32) leaves 0.6 = 3 layers of 3d print for the case? | 20:05 |
| *** kcnickerson_____ has quit IRC | 20:58 | |
| *** thepatr1ck has quit IRC | 20:58 | |
| *** imdeni has quit IRC | 20:58 | |
| *** thepatr1ck has joined #tomu | 20:58 | |
| *** kcnickerson_____ has joined #tomu | 20:58 | |
| *** imdeni has joined #tomu | 20:58 | |
| *** im-tomu has left #tomu | 23:06 | |
| *** im-tomu has joined #tomu | 23:07 | |
| *** im-tomu has left #tomu | 23:13 | |
| *** im-tomu has joined #tomu | 23:13 | |
Generated by irclog2html.py 2.17.2 by Marius Gedminas - find it at https://mg.pov.lt/irclog2html/!