| *** tpb has joined #tomu | 00:00 | |
| *** Sigyn has left #tomu | 04:30 | |
| *** jluc has joined #tomu | 08:41 | |
| *** m2049r has joined #tomu | 09:17 | |
| m2049r | znoteer: what OS are you on? | 09:20 |
|---|---|---|
| m2049r | Does tomu flash when you are asked to touch? | 09:21 |
| *** awe00 has quit IRC | 10:08 | |
| *** notthetup has joined #tomu | 11:51 | |
| *** tyll has quit IRC | 12:44 | |
| *** tyll has joined #tomu | 12:45 | |
| *** awe00 has joined #tomu | 15:14 | |
| znoteer | m2049r: I'm on Linux (Debian stable, kernel 4.9.0). I've sort of got if working. tomu is very particular about how it gets touched. It wiggles in the USB port so I have to be careful not to make it reboot. As I write this, I am unable to make the LED turn on by touching the tomu. But, I do occasionally get it to work. (yes, it flashes when I'm asked to touch) | 16:20 |
| *** jluc has quit IRC | 16:59 | |
| *** awe00 has quit IRC | 17:09 | |
| *** awe00 has joined #tomu | 17:31 | |
| m2049r | So you have your udev rules sorted out. I would suggest you work on the stability. I have 3d-printed the case. But had a piece of plastic hot-glued & cut to size on the cpu side before that and it worked quite well - maybe better than the 3d- print. | 18:49 |
| znoteer | the cut-to-size and hot-glued pièce of plactic was added add to the 3d print that comes with tomu, or glued directly to the circuit board/cpu? | 18:52 |
| znoteer | s/added add/glued directly | 18:53 |
| m2049r | Glued directly to the board. (No 3d case) also maybe try a different usb port or hub. It seems different usb ports have slightly different dimensions. | 18:59 |
| znoteer | I've tried 3 ports in my laptop. I'm having troube finding exactly the right way to tickle this thing today. I've managed to make it boot chopstx sveral times without removing it from the port, and once got it into whatever the mode is where you can flash to it (flashing red and green) | 19:03 |
| znoteer | I'll try my hub but that will be much less convenient when it comes time to use it | 19:03 |
| znoteer | how thick was the plastic you hot glued to the cpu? | 19:04 |
| znoteer | m2049r: ^^ | 19:05 |
| znoteer | no, it's as loose and sloppy in my hubs | 19:07 |
| znoteer | (as it is in my laptop ports) | 19:07 |
| m2049r | It's like 0.8mm | 19:16 |
| m2049r | But you could try different strengths is cardboard | 19:17 |
| m2049r | s/is/of | 19:19 |
Generated by irclog2html.py 2.13.1 by Marius Gedminas - find it at mg.pov.lt!