| *** tpb has joined #tomu | 00:00 | |
| k-man | ok thanks | 00:00 |
|---|---|---|
| k-man | hmm, mine doesn't show up under /dev afaict. but it is detected when i plug it in. it flashes red and green | 00:03 |
| mijofa | k-man: Tried "udevadm monitor"? | 00:05 |
| k-man | i think it needs to be programmed with dfu-util | 00:07 |
| k-man | according to the email sent to the lca list | 00:07 |
| mijofa | Perhaps, I don't understand dfu enough to know whether you'd get "something" before doing that | 00:08 |
| k-man | me either :) | 00:08 |
| nullobject | It shows up as /dev/tty.usbmodem1421 for me. | 00:09 |
| k-man | nullobject, is that after flashing with the new firmware? | 00:10 |
| nullobject | no, old firmware. should i update first? | 00:10 |
| mijofa | Huh, the stamp-like thing the replaced the bootloader didn't replace the u2f firmware I put on it, that's surprising | 00:10 |
| k-man | unsure - the email imlies you can if you want | 00:10 |
| *** schnebbus has quit IRC | 00:11 | |
| k-man | it sounds as though the DFU firmware is very new | 00:12 |
| mijofa | AIUI, dfu itself is not, but for this device it is | 00:13 |
| mijofa | But then again, the device itself is still in dev. ;) | 00:13 |
| k-man | ok, mine shows up with sudo dfu-util -l | 00:13 |
| k-man | err yeah, i meant the dfu firmware for the tomu is new | 00:14 |
| *** drewww has quit IRC | 00:15 | |
| xobs | Yes, the red/green flashing means it's in DFU mode. | 00:15 |
| *** nullobject has quit IRC | 00:23 | |
| *** schnebbus has joined #tomu | 00:23 | |
| k-man | when i try and build the samples, i get: main.c:18:22: fatal error: capsense.h: No such file or directory | 00:23 |
| k-man | oh, nm, helps when you read the instructions | 00:28 |
| *** justinfuhrmie has joined #tomu | 00:28 | |
| k-man | ok, managed to flash it | 00:30 |
| xobs | Grats! | 00:36 |
| xobs | k-man: To get back into the bootloader, short out the outer pins as you plug it in. Tweezers can be handy. | 00:36 |
| xobs | (I'm open to suggestions for alternate methods to boot to DFU, if anyone has ideas.) | 00:36 |
| k-man | xobs, thanks! i was wondering that | 00:36 |
| *** drewww has joined #tomu | 00:41 | |
| *** drewww has quit IRC | 00:41 | |
| *** drewww has joined #tomu | 00:41 | |
| mijofa | xobs: Those outer pins are meant to work as capacitive touch sensors, can you just touch the while you plug it in to get the same effect? | 00:41 |
| *** auscompgeek has joined #tomu | 00:42 | |
| xobs | mijofa: It could work, but the issue I'd see is that you generally push the board into the slot from the edge, so it would always go into DFU mode when you plugged it in. | 00:43 |
| *** schnebbus has quit IRC | 00:45 | |
| justinfuhrmie | I tried this, but I don't think I'm conductive enough | 00:45 |
| *** Deltadk has quit IRC | 00:46 | |
| *** nullobject has joined #tomu | 00:48 | |
| *** SergeiG has quit IRC | 00:54 | |
| *** SergeiG has joined #tomu | 00:56 | |
| *** schnebbus has joined #tomu | 01:03 | |
| *** nullobject has quit IRC | 01:05 | |
| *** TheJJ has quit IRC | 01:11 | |
| *** nullobject has joined #tomu | 01:12 | |
| *** drewww has quit IRC | 01:22 | |
| *** im-tomu has quit IRC | 01:25 | |
| *** im-tomu has joined #tomu | 01:27 | |
| *** justinfuhrmie has quit IRC | 01:32 | |
| *** nullobject has quit IRC | 01:34 | |
| *** schnebbus has quit IRC | 01:36 | |
| *** Deltadk has joined #tomu | 01:38 | |
| *** Deltadk has quit IRC | 01:44 | |
| *** Deltadk has joined #tomu | 01:48 | |
| *** nullobject has joined #tomu | 02:21 | |
| *** thex has quit IRC | 02:25 | |
| *** nullobject has quit IRC | 02:48 | |
| *** nullobject has joined #tomu | 03:35 | |
| *** nullobject has quit IRC | 03:45 | |
| *** nullobject has joined #tomu | 04:39 | |
| *** justinfuhrmie has joined #tomu | 04:49 | |
| *** drewww has joined #tomu | 05:07 | |
| *** nullobject has quit IRC | 05:08 | |
| *** nullobject has joined #tomu | 05:39 | |
| *** drewww has quit IRC | 05:56 | |
| *** kskdkdkfkfjjjd has joined #tomu | 06:05 | |
| *** nrossi has joined #tomu | 06:17 | |
| *** kskdkdkfkfjjjd has quit IRC | 06:34 | |
| *** nullobject has quit IRC | 06:38 | |
| *** justinfuhrmie has quit IRC | 06:43 | |
| *** nullobject has joined #tomu | 06:56 | |
| *** nullobject has quit IRC | 07:30 | |
| *** nullobject has joined #tomu | 07:55 | |
| *** Dufa_ has joined #tomu | 08:28 | |
| *** Dufa_ has quit IRC | 08:33 | |
| *** plaes has quit IRC | 09:11 | |
| *** plaes has joined #tomu | 09:11 | |
| *** nullobject has quit IRC | 09:19 | |
| *** spidie has joined #tomu | 09:36 | |
| spidie | Hi All, got a Tomu (v0.3) from Tim & Xobs at LCA - on linux, I was expecting to see a tty serial device, but instead I just get: | 09:40 |
| spidie | [ 2101.019204] usb 3-1: new full-speed USB device number 14 using xhci_hcd | 09:40 |
| spidie | [ 2106.426561] usb 3-1: new full-speed USB device number 15 using xhci_hcd | 09:40 |
| spidie | [ 2106.568232] usb 3-1: New USB device found, idVendor=1209, idProduct=70b1 | 09:40 |
| spidie | [ 2106.568236] usb 3-1: New USB device strings: Mfr=1, Product=2, SerialNumber=0 | 09:40 |
| spidie | [ 2106.568239] usb 3-1: Product: Tomu Bootloader | 09:40 |
| spidie | [ 2106.568240] usb 3-1: Manufacturer: xobs | 09:40 |
| *** spidie has quit IRC | 09:40 | |
| *** spidie has joined #tomu | 09:57 | |
| spidie | oops - I got banned for the paste - will try again on pastebin! | 09:57 |
| spidie | (haven't used IRC in so long!) | 09:57 |
| spidie | https://pastebin.com/raw/0pzT5uR4 | 09:59 |
| spidie | do I have to do some udev rules or anything for tomu? | 09:59 |
| SergeiG | looks like you board has DFU bootloader preinstalled | 10:00 |
| SergeiG | just use dfu-util to flash it | 10:01 |
| *** benbarclay has joined #tomu | 10:02 | |
| spidie | cool - thanks for that. Didn't think DFU was around yet. I think when I put it on xobs test jig at LCA it flashed it. | 10:03 |
| spidie | I was probably not listening when he told me! doh | 10:04 |
| benbarclay | There is supposed to be a red LED on the tomu right? | 10:04 |
| spidie | flashing red and green at moment. | 10:04 |
| spidie | pretty fast | 10:04 |
| benbarclay | I've uploaded the blinker program and I can only get the green light going :S | 10:04 |
| spidie | I'll try dfu-util now - thanks SergeiG | 10:06 |
| *** benbarclay has quit IRC | 10:10 | |
| *** benbarclay has joined #tomu | 10:12 | |
| *** benbarclay has quit IRC | 10:26 | |
| *** spidie has quit IRC | 10:31 | |
| *** auscompgeek has quit IRC | 14:52 | |
| *** auscompgeek has joined #tomu | 14:56 | |
| *** TheJJ has joined #tomu | 15:57 | |
| *** impactful has joined #tomu | 17:04 | |
| *** impactful has quit IRC | 17:33 | |
| *** shenki has quit IRC | 17:55 | |
| *** NoGodDamnIdea has joined #tomu | 18:37 | |
| *** GuyNoIR has quit IRC | 18:42 | |
| *** GuyNoIR has joined #tomu | 18:47 | |
| *** GuyNoIR has joined #tomu | 18:47 | |
| *** nrossi has quit IRC | 20:56 | |
| *** schnommus has joined #tomu | 21:32 | |
| *** NoGodDamnIdea has quit IRC | 22:28 | |
| *** schnommus has quit IRC | 22:32 | |
| *** NoGodDamnIdea has joined #tomu | 22:39 | |
| *** thex has joined #tomu | 22:46 | |
| *** DocJosh has joined #tomu | 23:27 | |
| *** thex has quit IRC | 23:28 | |
| *** drewww has joined #tomu | 23:47 | |
Generated by irclog2html.py 2.13.1 by Marius Gedminas - find it at mg.pov.lt!