Friday, 2018-12-28

*** tpb has joined #timvideos00:00
*** futarisIRCcloud has quit IRC00:43
*** springermac has joined #timvideos01:18
*** mauz555 has joined #timvideos01:23
*** mauz555 has quit IRC01:34
*** futarisIRCcloud has joined #timvideos02:56
*** futarisIRCcloud has quit IRC05:06
*** rohitksingh has joined #timvideos05:24
CarlFK[email protected]:~ $ a https://cdn.c3voc.de/hls/s150_native_hd.m3u805:56
* CarlFK[m] uploaded an image: scv_15459736738661329501093748365533.jpg (372KB) < https://matrix.org/_matrix/media/v1/download/matrix.org/xKNjhaIsVPYkLSIxvhDsGuGH >05:56
*** Kripton has quit IRC07:22
*** Kripton has joined #timvideos07:30
*** CarlFK has quit IRC08:25
*** rohitksingh_ has joined #timvideos08:26
*** rohitksingh has quit IRC08:26
*** CarlFK has joined #timvideos08:43
*** ChanServ sets mode: +v CarlFK08:43
rohitksingh_CarlFK: it took me a while to figure out the orientations in that image :p09:02
CarlFKheh09:02
CarlFKlocal hackersace, I hooked a pi up to the projector09:02
CarlFKhanging from power, hdmi and network - and an audio cable goes from the projector to a little speaker system behind me09:03
rohitksingh_nice! what are those other things hanging from the ceiling?09:04
CarlFKmore cat 5 and power cables I'm guessing09:13
CarlFKoh the coil things - yeah, power and silly long hdmi cable that tries to roll itself back up when you are done with it.09:15
CarlFKbut doesn't work too well :p09:15
rohitksingh_haha, okay :p09:24
*** rohitksingh_ has quit IRC10:39
*** rohitksingh has joined #timvideos11:06
mithroMy talk will be on in ~10 minutes!11:42
rohitksinghmithro: All the best! I'm following the live stream11:49
rohitksinghmithro: it was a nicely presented talk! exciting to know that soc demo on artix 7 is almost ready!13:04
*** TimGremalm has quit IRC14:20
*** TimGremalm has joined #timvideos14:22
*** rohitksingh has quit IRC15:22
*** rohitksingh has joined #timvideos16:27
cr1901_modernAhhh shit I was asleep during the talk16:31
mithrocr1901_modern: Why is this not fixed -> https://github.com/timvideos/litex-buildenv/issues/9817:22
cr1901_modernBecause I can't upload a new version of tinyprog to pypi :)17:25
mithrocr1901_modern: But we can just install directly from github like other things?17:26
cr1901_modernOh. Right. Then it's only not fixed because I forgot that pip supports git+https :)17:27
CarlFKmithro: how long till your next talk? (1 hour I think?)17:30
CarlFKhttps://streaming.media.ccc.de/35c3/chaoswest has pic in pic in pic ;)17:35
tpbTitle: Chaos West Bühne – 35C3 Streaming (at streaming.media.ccc.de)17:35
cr1901_modernmithro: https://github.com/timvideos/litex-buildenv/pull/11917:37
tpbTitle: Install tinyprog from repo until new version is uploaded to PyPI. by cr1901 · Pull Request #119 · timvideos/litex-buildenv · GitHub (at github.com)17:37
mithrocr1901_modern: Can you confirm that works from fresh install please?17:37
mithroCarlFK: ~2 hours I think?17:39
CarlFKmithro: thanks.  also, does fpga minconf setup test the "Install tinyprog" you just asked about?   because I can test that easy17:41
mithroCarlFK: No17:42
mithroCarlFK: The FuPy on ice40 does17:42
cr1901_modernmithro: Installed fine from a fresh install w/ that patch17:49
mithrocr1901_modern: Can you test to see if the stub firmware booting is working?17:58
cr1901_modernmithro: Right now I can't, sorry18:00
*** rohitksingh has quit IRC19:01
*** rohitksingh has joined #timvideos19:27
CarlFKhttps://streaming.media.ccc.de/35c3/hallb  this is where tim will be in 20 min right?19:50
tpbTitle: Borg – 35C3 Streaming (at streaming.media.ccc.de)19:50
tumbleweedhe's there now19:54
CarlFKthanks19:56
*** rohitksingh has quit IRC22:14

Generated by irclog2html.py 2.13.1 by Marius Gedminas - find it at mg.pov.lt!