Friday, 2016-05-13

*** tpb has joined #timvideos00:00
*** ssk1328_ has joined #timvideos04:39
*** ssk1328_ has quit IRC05:51
*** aom has quit IRC06:36
*** se6astian|away is now known as se6astian06:42
mithrocr1901_modern: so how does that frequency counter go?06:45
*** sb0 has quit IRC07:01
*** Bertl is now known as Bertl_zZ08:24
*** sab_123 has joined #timvideos08:35
*** sab_123 has quit IRC08:52
* tumbleweed now has a multimeter with him09:52
ssk1328mithro: Did you review the project description I updated yesterday?12:16
*** sb0 has joined #timvideos13:37
*** se6astian is now known as se6astian|away14:04
*** se6astian|away is now known as se6astian15:08
*** sb0 has quit IRC15:13
*** se6astian is now known as se6astian|away15:16
*** Bertl_zZ is now known as Bertl15:30
*** cr1901_modern1 has joined #timvideos15:31
*** cr1901_modern has quit IRC15:34
*** sb0 has joined #timvideos16:15
*** _florent_ has quit IRC16:58
*** deeprave has quit IRC16:58
cr1901_modern1mithro: The counter's done but untested. I was having trouble building a test SoC with the frequency counter earlier (Xilinx kept eating my sequential logic), but sb0 helped me figure out what was wrong.17:08
*** deeprave has joined #timvideos17:11
*** _florent_ has joined #timvideos17:16
*** se6astian|away is now known as se6astian17:27
tumbleweedmithro: voltage levels on this opsis seem sane, except 3.3 is a little low at 3.117:43
CarlFKtumbleweed: any clue where I should document jumper settings?  like some tv/opsis/wiki page around here?19:58
tumbleweedCarlFK: it seems some are documented here:
CarlFK  aka fixme.jpg20:00
CarlFK  %[include board/jumpers]  wat?20:22
tpbTitle: HDMI2USB-numato-opsis-docs/ at master · timvideos/HDMI2USB-numato-opsis-docs · GitHub (at
*** se6astian has left #timvideos21:37
*** sb0 has quit IRC23:43
*** Bertl is now known as Bertl_zZ23:43

Generated by 2.13.1 by Marius Gedminas - find it at!